Output Sequence Editor; Require Output Sequence - Hand Held Products 2020 User Manual

69 code identifier for Code 93
9999 code length that must match for Code 93, 9999 = all lengths
43 start character match for Code 93, 43h = "C"
FF termination string for third code
To program the previous example using specific lengths, you would have to
count any programmed prefixes, suffixes, or formatted characters as part of the
length. If you use the example on
specific code lengths, you would use the following command line:
SEQBLK62001241FF6A001342FF69001243FF
The breakdown of the command line is shown below:
SEQBLK sequence editor start command
62 code identifier for Code 39
0012 A - Code 39 sample length (11) plus CR suffix (1) = 12
41 start character match for Code 39, 41h = "A"
FF termination string for first code
6A code identifier for Code 128
0013 B - Code 128 sample length (12) plus CR suffix (1) = 13
42 start character match for Code 128, 42h = "B"
FF termination string for second code
69 code identifier for Code 93
0012 C - Code 93 sample length (11) plus CR suffix (1) = 12
43 start character match for Code 93, 43h = "C"
FF termination string for third code

Output Sequence Editor

Enter Sequence

Require Output Sequence

When an output sequence is Required , all output data must conform to an edited
sequence or the image scanner will not transmit the output data to the host
device. When it's On/Not Required , the image scanner will attempt to get the
output data to conform to an edited sequence, but if it cannot, the image scanner
transmits all output data to the host device as is.
2020/4820/4820 i User's Guide
page 4-18, but assume a <CR> suffix and
Default Sequence
4 - 19