Output Sequence Editor; Require Output Sequence - Hand Held Products 2020 User Manual

ogy and scan the 2 digit hex value from the
back cover of this manual.
3. Length
Specify what length (up to 9999 characters) of data output will be acceptable
for this symbology. Scan the four digit data length from the
Chart inside the back cover of this manual. (Note: 50 characters is entered
as 0050. 9999 is a universal number, indicating all lengths.) When calculat-
ing the length, you must count any programmed prefixes, suffixes, or format-
ted characters as part of the length (unless using 9999).
4. Character Match Sequences
On the ASCII Conversion Chart (Code Page 1252)
value that represents the character(s) you want to match. Use the
ming Chart inside the back cover of this manual to read the alphanumeric
combination that represents the ASCII characters. (99 is the Universal num-
ber, indicating all characters.)
5. End Output Sequence Editor
Scan F F to enter an Output Sequence for an additional symbology, or Save
to save your entries.
Other Programming Selections
• Discard
This exits without saving any Output Sequence changes.

Output Sequence Editor

Enter Sequence

Require Output Sequence

When an output sequence is Required , all output data must conform to an edited
sequence or the image scanner will not transmit the output data to the host
device. When it's On/Not Required , the image scanner will attempt to get the
output data to conform to an edited sequence, but if it cannot, the image scanner
transmits all output data to the host device as is.
When the output sequence is Off , the barcode data is output to the host as the
image scanner decodes it.
3 - 10
Programming Chart
on page A-2, find the Hex
Default Sequence
2020/3820 User's Guide
inside the
Programming
Program-