Starting The Vcs Program With Expansion Cards - Extron electronics Quantum Ultra Series User Manual

Starting the VCS Program with Expansion Cards

There are some differences in the procedure for starting a VCS project for a system
containing expansion cards. To set up an expansion project:
1. On the Start screen, select the Quantum Ultra 305/610 radio button.
NOTE:
On the New Project screen, each listed device with expansion cards is preceded
2.
by a Configure Expansion button (in place of the Add to System button, see
figure 78,
devices. (Figure 78 shows an expansion system with two chassis. There can be up to
five chassis in an expansion system.)
Figure 78.
The Confirm Expansion System window opens, showing the IP addresses of all
3.
Quantum Ultra devices with expansion cards, listed in their order in the chain, with
the primary device at the top. If all the information on this screen is correct, click the
Confirm button at the bottom of the screen.
Figure 79.
NOTE: If the IP address of a connected device in the chain is not found, this
window indicates which device is missing. Click Cancel to return to the New
Project connection screen.
A prompt window appears, indicating that the initial configuration is complete and that
the system will reboot.
4. Click OK on the prompt to close it. The reboot starts automatically and takes a
few minutes to complete.
Quantum Ultra Series Videowall Processing Systems • Remote Configuration and Control
Expansion cards are not supported on the Quantum Ultra II models.
). Click the Configure Expansion button for any one of the expansion
1
Connection Screen for an Expansion System
Confirm Expansion System Prompt
87