Table of Contents
Advertisement
Centre - press to confirm selection.
▼
Horn Button
When the horn button is pushed, with
the ignition switch turned on, the horn
will sound.
Heated Grips Switch (if fitted)
The heated grips will only heat when
the engine is running.
When the heated grips are switched on,
the heated grips symbol will appear in
the display and the selected heat level
will be shown.
There are three levels of heat: low,
medium and high. This is indicated by
the different colours of the symbols
shown in the display.
1
1.
Low heat symbol (yellow)
2.
Medium heat symbol (orange)
3.
High heat symbol (red)
For maximum benefit in cold conditions,
from the OFF position press the switch
once for the high heat setting initially
and then reduce the heat level by
pressing the switch again for a low heat
setting when the grips have warmed up.
To turn off the heated grips, press and
release the switch until the heated
grips symbol is no longer shown in the
display.
Low Power Voltage Cut Off
If a low voltage is detected, the heated
grips will power off. The heated grips
will not function again until the voltage
rises to a safe level.
2
3
GENERAL INFORMATION
The heated grips will not power back on
automatically even if the voltage rises to
the safe level. The heated grips switch
must be manually pressed again to
activate the heated grips.
Fog Lights Switch (if fitted)
The fog lights switch will only operate
when the headlights are on. The fog
lights switch will reset to off when the
ignition is turned off then on again.
To turn the fog lights on or off, make
sure that the headlights are on and
then press and release the fog lights
switch. When the fog lights are turned
on, the fog lights indicator will illuminate
in the display.
High Beam Button
The high beam button has a different
function depending on whether Daytime
Running Lights (DRL) are fitted or not.
When the high beam is turned on, the
high beam indicator light will illuminate
in the display.
Models with Daytime Running Lights
(DRL)
If the DRL switch is in the Daytime
Running Lights (DRL) position, then
press and hold the high beam button
to turn the high beam on. It will remain
on as long as the button is held in and
will turn off as soon as the button is
released.
If the DRL switch is in the dip beam
position, press the high beam button to
switch the high beam on. Each press of
the button will swap between dip and
high beam.
59
Advertisement
Chapters
Table of Contents
