Flushing Procedure In Conjunction With Epg 2008/Epg Prima Control Unit; Reproducible Setting Of The Nozzle Position - WAGNER PEM-C4-Ergo Original Operating Manual

VERSION 02/2009
OPERATING MANUAL
6.3.2

FLUSHING PROCEDURE IN CONJUNCTION WITH EPG 2008/EPG PRIMA CONTROL UNIT

If the spray gun is operated with an EPG 2008/EPG Prima control unit and a PI-P1 powder
injector, proceed as follows:
1. Release the trigger on the spray gun so that the powder feed and high-voltage
generator are switched off.
2. Set the knob for the overall air quantity on the EPG 2008/EPG Prima control unit to
maximum. No more powder will be delivered when switching on again.
3. Press the trigger on the spray gun so that the spray gun is blown free of powder.
4. Switch off the control unit and secure against inadvertent switch on.
5. Disconnect the powder hose from the spray gun.
6. Clear the spray gun using the air gun and clear any residues of powder.
7. Before you commence to connect the powder hose again, all parts carrying powder
must be thoroughly cleaned.
8. The spray gun is ready for use again.
6.4

REPRODUCIBLE SETTING OF THE NOZZLE POSITION

30°
15°
0°
X
ORDER NUMBER DOC2305054
For a horizontal powder cloud, the fan
●
spray nozzle is set where the protective
wedge is in the 0° position.
When attaching a round spray nozzle,
●
we recommend turning the protective
wedge in the 90° position to achieve a
X
smoother coating (the protective wedge
is now in the vertical position).
It is possible to set it other positions for
special applications.
On the nozzle body and electrode
holders there are X markings. In 15° steps, the
position can be changed if necessary and
reproducibly.
P_01095
The outer nut has to be removed for exact
positioning.
An adjustment tool is provided for the fan
spray nozzle.
It permits turning the fan spray nozzle
without damaging the electrodes and
without removing the outer nut.
The outer nut only has to be slackened.
P_01096
PEM-C4-Ergo.
23