Connecting The Spray Gun - WAGNER PEM-C4-Ergo Original Operating Manual

VERSION 02/2009
OPERATING MANUAL
5.2

CONNECTING THE SPRAY GUN

Unintentional putting into operation!
Risk of injury
Before all work on the unit, in the event of work interruptions and
functional faults:
SIHI_05057_ENG
Procedure:
1. Switch off the high-voltage generation at the control unit.
2. Connect the spray gun to the control unit using the electrical cable.
3. Connect the powder feed hose to the spray gun and to the powder injector.
4. Connect the atomizing air hose to the spray gun and to the control unit.
Hint:
Using a Wagner PI-F1 powder injector and a suitable control unit, it is possible to
automatically blow out or purge the spray gun each time prior to switch off.
ORDER NUMBER DOC2305054
WARNING
Switch off the energy/compressed air supply.
Relieve spray gun and unit pressure.
Secure the spray gun against actuation.
In the event of functional faults, remedy the fault as described in
the "Troubleshooting" chapter.
P_01094
to the electrical
connection at the
control unit
Atomizing air from the
control unit
Powder feed from the
powder injector
PEM-C4-Ergo.
18