Replacing The Centring Pins - WAGNER PEM-C4-Ergo Original Operating Manual

VERSION 02/2009
OPERATING MANUAL
7.9

REPLACING THE CENTRING PINS

The charging body is secured in place in the gun extension with 3 centring pins. Over time,
the centring pins wear and in this case, must be exchanged for new centring pins. The
amount of wear can be determined by a visual check or when the charging body exhibits
an amount of play in the gun extension.
Procedure:
4
1
P_00926
1. Withdraw defl ector cone 1 or fan spray nozzle 2 and atomizer sleeve 3 from the gun
extension 4.
2. Unscrew the defl ector cone sleeve 5 from the gun extension 4.
3. Pull out the worn centring pins 6 and insert new ones.
4. Center the charging body in the outer tube using centring pins 6.
5. Screw the defl ector cone sleeve 5 back onto the gun extension 4.
6. Depending on the planned usage, either locate defl ector cone 1 or atomizer sleeve 3
and fan spray nozzle 2 carefully on the gun extension 4.
7. The spray gun is ready for use again.
ORDER NUMBER DOC2305054
3
2
6
5
P_00930
PEM-C4-Ergo.
4
40