Maintenance - jbc JNAU Instruction Manual

Maintenance

Before carrying out maintenance, always switch the
station off and disconnect it from the mains. Allow the
equipment to cool down.
- Clean the station screen with a glass cleaner or a
damp cloth.
- Use a damp cloth to clean the casing and the tool.
Alcohol can only be used to clean the metal parts.
- Periodically check that the metal parts of the tool and stand
are clean so that the station can detect the tool status.
- Periodically check all cables and tubes.
- Replace a blown fuse as follows:
1. Pull off the fuse holder and remove the
fuse. If necessary use a tool to lever it off.
Use only with a 250V fuse
Use only with a 250V fuse
Employer uniquement avec
Employer uniquement avec
un fusible de 250V
un fusible de 250V
- Replace any defective or damaged pieces. Use original JBC spare parts only.
- Repairs should only be performed by a JBC authorized technical service.
10
Made in EU
Made in EU
PATENTED
PATENTED
85-265V 50/60Hz
85-265V 50/60Hz
Power 70W
Power 70W
STAND
Main Fuse T2 A
Main Fuse T2 A
Serial 219801-026
Serial 219801-026
Version 5A
Version 5A
ROBOT
JNAU
JNAU
Station
Station
Fuse holder
Fuse holder
PEDAL
PEDAL
STAND
AUX
ROBOT AUX
2. Insert the new fuse into the fuse holder and
return it to the station.
Clean
periodically
Fuse
Fuse
Fuse holder
Fuse holder