Connecting The Wind Vane; Verifying Installation - Vaisala WAV151 User Manual

3.3 Connecting the Wind Vane
Vaisala recommends using the SOURIAU UTS6JC12E10P cable connector for the
sensor.
1. Connect the heating element in the shaft tunnel between pins J and K.
2. Supply the heating element with 20 VDC or VAC.
3.4 Verifying Installation
1. Make sure that the sensor is powered up and connected to the data collection system.
2. Rotate the cup wheel manually and make sure the speed readings change.
Figure 3 WAV151 Connector Sensor Side
A D+, power input from 9.5 to 15.5 VDC
B GND, common ground
C G5, signal output
D G4, signal output
E G3, signal output
F G2, signal output
G G1, signal output
H G0, signal output
J HTNG, 20 VDC or VAC
K HTNG, 20 VDC or VAC
Figure 4 WAV151 Connector Cable Side
Chapter 3 – Installation
11