Replace The Air Filter Bowl And Filter Element; Remove The Air Filter Bowl And Filter Element - Hypertherm Powermax65 SYNC Manual

Replace the air filter bowl and filter element

For kit contents, refer to

Remove the air filter bowl and filter element

1. Set the power switch on the plasma power
supply to OFF (O).
2. Disconnect the power cord from electrical
power.
3. Disconnect the gas supply from the rear of the
plasma power supply.
4. Hold the filter bowl with your right hand. With
the index finger of your left hand, push down
the latch and turn the filter bowl
1
approximately 45 degrees to the right.
5. Pull the filter bowl straight down to remove.
6. Gently turn and pull the filter element
O-ring at the top of the bowl.
3
Powermax65/85 SYNC Service Parts and Procedures
Plasma power supply exterior, rear
out of the filter bowl. Be careful not to damage the
2
810440
Service Procedures for the Gas Line
on page 17.
1
2
3
2
4
81