Replace The Air Filter Bowl And Air Filter Element - Hypertherm powermax30 air Service Manual

Replace the air filter bowl and air filter element

Kit number
428378
428380
Remove the air filter bowl and air filter element
1. Complete the following procedures:
a. Set the power switch to OFF (O), and disconnect the power cord from the power source.
b. See Remove the power supply cover on page 98.
2. From the fan side of the power supply, disconnect the drain hose
bowl.

It is normal to see water in the drain hose and in the air filter bowl. Remove any water that
spills inside the power supply before operating the system again.

If you need better access to the air filter, remove the fan plenum
needlenose pliers to compress and release the plenum's top 2 corner clips first before
working the bottom 2 clips free from the fan casing.
3. Hold the top of the air filter assembly
remove it.
3
Powermax30 AIR Service Manual 808850
Description
Kit: Air filter element
Kit: Air filter bowl (includes air filter element, O-ring, and drain hose)
steady with one hand. With your other hand, unscrew the air filter bowl
4
6 – Power Supply Component Replacement
from the fitting
1
. Use a pair of
3
Figure 66
1
at the bottom of the air filter
2
4
5
2
to
5
151