Replace The Air Filter Assembly - Hypertherm XPR170 Replacement Part Procedures

Replace the air filter assembly


Refer to
page 143 for location and part number.
1. Complete the following procedures:
a. Remove the power from the cutting system.
b. Remove the gas pressure from the cutting system.
c. Remove the top panel.

Refer to

Keep all nuts and screws that you remove.
2. Disconnect the hoses
from the
push-to-connect fittings.
Refer to How to use
push-to-connect fittings
on page 68.
3. Use a 3 mm,
hexagonal-key wrench to
remove the 2 screws.
4. Remove the air filter
assembly.
5. Remove the 2 fittings.
6. Install the 2 fittings onto
the new air filter
assembly.
7. Use the 2 screws to
install the air filter
assembly.
8. Connect the hoses to the push-to-connect fittings. Refer to
fittings on page 68.
9. Install the top panel.
XPR170 Field Service Bulletin
Core, VWI, and OptiMix gas connect console manifold side
Gas connect console panels
810410
on page 100.
How to use push-to-connect
2
Gas Connect Consoles
on
79