Replace The Air Filter Assembly - Hypertherm XPR300 Replacement Part Procedures

Replace the air filter assembly


See Core, VWI, and OptiMix gas connect console manifold side on
page 131 for location and part number.
1. Complete the following procedures:
a. Remove the power from the cutting system.
b. Remove the gas pressure from the cutting system.
c. Remove the top panel.

See Gas connect console panels on page 87.

Keep all nuts and screws that you remove.
2. Disconnect the hoses
from the
push-to-connect fittings.
See How to use
push-to-connect fittings
on page 66.
3. Use a 3 mm,
hexagonal-key wrench to
remove the 2 screws.
4. Remove the air filter
assembly.
5. Remove the 2 fittings.
6. Install the 2 fittings onto
the new air filter
assembly.
7. Use the 2 screws to
install the air filter
assembly.
8. Connect the hoses to the push-to-connect fittings. See How to use push-to-connect fittings on
page 66.
9. Install the top panel.
XPR300 Field Service Bulletin 809970
2
Gas Connect Consoles
77