Model Establishment And Illustration - ANDELI TIG Series Instruction Manual

4. Installation of the machine
The power supply of this series of products should be single phase AC 220V 50/60Hz. Use
a distribution cabinet with an automatic air switch. Ensure safe grounding.
4.1 MMA welding：
 Connect welding cable to the machine.
 Turn off the machine.
 Connect the input cable to the distribution cabinet, switch on.
4.2 Hot/Cold TIG welding：
 Connect the earth cable to the positive pole, TIG torch to the negative pole.
 Connect the hose to the machine and gas bottle.
 Turn off the machine.
 Connect the input cable to the distribution cabinet, switch on.
4.3 Clean welding：
 Connect the earth cable to the positive pole, TIG torch to the negative pole.
 Turn off the machine.
 Connect the input cable to the distribution cabinet, switch on.

Model establishment and illustration

TIG series welding machine model establishment and description as shown in figure 1：
T I G
( Figure 1) TIG series welding machine model establishment and description.
×××
—
Model
Argon tungsten arc welding
- 10 -