ANDELI TIG Series Instruction Manual page 16

Display the values of each parameter；
Welding function indicator light：
5
Parameter light：
6
lamp is off to adjust the interval time；
selection button to store welding parameters and built-in parameters ； There are 9 channels
respectively, channel 0-4 store the self-tuning parameters and channel 5-8 save the Built-in
parameters；
Save Function ： For example, select channel 0 in advance, adjust the corresponding
Built-in parameters in TIG welding mode：U5-D0.8，spot welding 0.8mm workpiece；
Built-in parameters in TIG interval welding mode： P5-P8， weld 0.6mm， 1.0mm， 1.5mm， 3.0mm
CLEAN，clean the color of the workpiece after argon arc welding；
TIG；
MMA；
TIG Interval，similar to automatic spot welding function；
Current light；adjust the current value under Clean and TIG mode；
Cold clean C5-C9, hot clean H10-H40 under Clean mode；
Under TIG interval mode, the lamp is on to adjust the current value, and the
Gas delay indicator；Under TIG mode,the time range of adjusting gas delay
is 0-10s；
Under TIG interval mode, gas delay time fixed in 2.5S；
Storage indicator； Under TIG、 TIG interval mode， long press the parameter
parameters,and then long press the parameter selection button to
automatically jump to the next channel, and the parameters of channel 0
will be saved;And so on;
U6-L0.8，Continuous welding 0.8mm workpiece；
U7-D3.0，spot welding 3.0mm workpiece；
U8-L3.0，Continuous welding 3.0mm workpiece；
- 15 -