ANDELI TIG Series Instruction Manual page 20

Under MMA：Gently touch the knob to select the electrode diameter (1.6/2.0/2.5/3.2) from
small to large, and adjust the knob to change the current on the corresponding electrode；
Digital tube：
4
Display the values of each parameter；
Welding function indicator light：
5
MMA；
discoloration；
Parameter light：
6
and TIG mode；
Under Cold moode ： Adjust the welding time 1-250ms, 1-200ms range has the effect of
Save indicator light；Long press the parameter selection key to store welding
TIG；
COLD ， Suitable for sheet welding, can reduce the degree of workpiece
CLEAN ,clean the color of the workpiece after argon arc welding；
Current, interval indicator; adjust the current value under cleaning
Adjust the interval time under Cold mode；
Cold clean C5-C9, hot clean H10-H40 under Clean mode；
Gas delay indicator；Under TIG mode, adjust the gas delay time 0-10S；Set
the gas delay time of cold welding in the mean time ；
reducing the welding temperature, the smaller the value, the
lower the temperature, the smaller the degree of workpiece
discoloration ； The range of 200-250ms has the effect of
inter-heat insulation pulse, continuous spot welding output, to
meet the requirements of penetration control, the degree of
workpiece color is close to ordinary argon arc welding;
parameters and built-in parameters under TIG and COLD mode ；
Both mode have 9 channels, 0-4 channels store self-adjusting
parameters and 5-8 built-in parameters;
- 19 -