ANDELI TIG Series Instruction Manual page 18

Welding function indicator light：
5
discoloration；
Parameter light：
6
Under Cold mode：Adjusting welding time 1-250ms，It has the effect of reducing welding
Built-in parameters in TIG welding mode：U5-D0.8，spot welding 0.8mm workpiece；
CLEAN，clean the color of the workpiece after argon arc welding；
TIG；
COLD ， Suitable for sheet welding, can reduce the degree of workpiece
Adjust interval time under Cold welding mode；
Current indicator light；Adjust current value under Clean、TIG mode；
Cold clean C5-C9, hot clean H10-H40 under Clean mode；
It's useless under Cold welding mode；
Gas delay indicator；Under TIG mode, adjust the gas delay time 0-10S；Set
the gas delay time of cold welding in the mean time ；
temperature. The range of 1-200ms has the effect of reducing the welding
temperature. The smaller the value, the lower the temperature, and the
smaller the degree of workpiece discoloration；The range of 200-250ms has
the effect of heat interval pulse, continuous spot welding output to meet the
requirements of penetration control, the degree of workpiece color is close
to ordinary argon arc welding；
Save indicator light ； Long press the parameter selection key to store
welding parameters and built-in parameters under TIG and COLD
mode； Both mode have 9 channels, 0-4 channels store self-adjusting
parameters and 5-8 built-in parameters;
Storage function: for example, select channel 0 in advance, adjust the
corresponding parameters, and then long press the parameter
selection key to automatically jump to the next channel, and the
parameters of channel 0 will be saved;And so on...
U6-L0.8，Continuous welding 0.8mm workpiece；
- 17 -