ANDELI TIG Series Instruction Manual page 14

Welding function indicator light：
5
Parameter light：
6
lamp is off to adjust the interval time；
Save Function ： For example, select channel 0 in advance, adjust the corresponding
Built-in parameters in TIG welding mode： U5-D0.8， spot welding 0.8mm workpiece ；
Built-in parameters in TIG interval welding mode：P5-P8，weld 0.6mm，1.0mm，
1.5mm，3.0mm workpiece；
Clean，clean the color of the workpiece after argon arc welding；
TIG；
TIG Interval，similar to automatic spot welding function；
Current light；adjust the current value under Clean and TIG mode；
Cold clean C5-C9, hot clean H10-H40 under Clean mode；
Under TIG interval mode, the lamp is on to adjust the current value, and the
Gas delay indicator；Under TIG mode,the time range of adjusting gas delay
is 0-10s；
Under TIG interval mode, gas delay time fixed in 2.5S；
Storage indicator；Under TIG、TIG interval mode，long
press the parameter selection button to store welding parameters and
built-in parameters；There are 9 channels respectively, channel 0-4
store the self-tuning parameters and channel 5-8 save the Built-in
parameters；
parameters, and then long press the parameter selection button to
automatically jump to the next channel, and the parameters of channel 0
will be saved;And so on;
U6-L0.8，Continuous welding 0.8mm workpiece；
U7-D3.0，spot welding 3.0mm workpiece；
U8-L3.0，Continuous welding 3.0mm workpiece；
- 13 -