ANDELI TIG Series Instruction Manual page 22

1.1.2 Welding output interface
From the left in order is：
Positive output fast socket： connect the electrode holder when on MMA mode； connect
1
ground clamp when hot welding、cold welding、clean；
Welding torch switch：connect with TIG torch and cleaning torch switch；
2
Negative output fast socket：connect the ground clamp when on MMA mode；connect
3
the cleaning torch fasst plug when on CLEAN mode；
Negative output gas-electric connector: connect the TIG torch electrical contact when
4
hot welding and cold welding；
2.Installation instruction：
Note: Please strictly follow below steps to install and debug!
Before electrical connect operation the user has to turn off the power switch of the
distribution panel!
This equipment protection level is IP21,avoid using in rain!
 Connect the welding input power wire to the corresponding voltage level and ≥60A circuit
breaker (connect the power wire ≥4²);
 The input power wire should be in good contact with the correspond power terminal or
switch ,to prevent oxidation
 Use a multimeter to measure whether the input voltage is in the fluctuation range;
 Connect the yellow-green wire on the power cable and the grounding screw on the rear
panel to ≥4² wire and ground well.；
 If the welder is placed on an inclined plane, the welder should be secured so that it does not
slip；
 Each welder is equipped with an insulated handle, which can be lifted by hand when moving
- 21 -