Installation - ANDELI TIG Series Instruction Manual

Installation

1. Environment
 Install in a dry environment with humidity less than 90% at 20℃ and 50% at 40℃.
 The temperature should be in the range of -10℃-40℃ when welding, and -20℃-55℃ for
storage and transportation.
 Shelter the machine from direct sunshine and rain. Avoid raindrops.
 Avoid using it in an environment with strong air flow when TIG welding.
 The inclination of the welding power is less than 10
 Avoid using it in a dusty, acid or other corrosive environment.
 The machine should be placed more than 20cm from the wall, and more than 10cm from
other welding machines.
2. Requirement of the input power source
 Waveform: standard pure sine wave
 Fluctuation range: 220V 15%
 Frequency: 50Hz/60Hz
3. Input power
Min. power of power grid
Input
protection
Cable
Enlarge the input , output and grounding cable according to the cable length.
Remark: the specifications of fuse and circuit breaker in the table above are only for reference.
Model
Input power
Fuse
Circuit breaker
input
output
ground
0 the altitude no more than 1000m.
TIG-200
1PH AC220V±15%，50/60Hz
7
40
63
2.5mm
16mm
2.5mm
- 9 -
2
2
2