ANDELI TIG Series Instruction Manual page 21

Storage function: for example, select channel 0 in advance, adjust the corresponding parameters,
and then long press the parameter selection key to automatically jump to the next channel, and
the parameters of channel 0 will be saved; And so on...
Built-in parameters in TIG welding mode：U5-D0.8，spot welding 0.8mm workpiece；
Built-in parameters in cold welding mode:C5-C8 0.4mm,0.8mm,1.5mm,2.0mm workpiece;
⑨ protected code：
Display OC, indicating welding machine overheat or overcurrent protection；
Overheat protection is that the internal temperature of the machine is overheated, and the
machine can be restored to normal after cooling without load；
Overcurrent protection is unrecoverable when the machine is turned on without load, and
there may be original damage inside the machine. This situation needs to be carefully
handled and confirmed before starting the machine；If it is a misjudgment, just restart the
machine。
U6-L0.8，Continuous welding 0.8mm workpiece；
U7-D3.0，spot welding 3.0mm workpiece；
U8-L3.0，Continuous welding 3.0mm workpiece；
- 20 -