ANDELI TIG Series Instruction Manual page 19

Built-in parameters in cold welding mode: C5-C8, welding 0.4mm,0.8mm,1.5mm,2.0mm
workpiece;
protected code：
9
Display OC, indicating welding machine overheat or overcurrent protection；
Overheat protection is that the internal temperature of the machine is overheated, and the
machine can be restored to normal after cooling without load；
Overcurrent protection is unrecoverable when the machine is turned on without load, and
there may be original damage inside the machine. This situation needs to be carefully
handled and confirmed before starting the machine；If it is a misjudgment, just restart the
machine。
function selector
1
function selector：switch MMA、TIG、COLD、CLEAN functions；
function selector：
2
Parameter selection key： Switch current、 gas delay、 cold welding time、 interval time、 long
press to save；
Parameter adjustment knob：
3
Adjust the size of each parameter value, keep long press can adjust roughly；
U7-D3.0，spot welding 3.0mm workpiece；
U8-L3.0，Continuous welding 3.0mm workpiece；
(Figure 7) TIG-250MPLC Panel
(the left first)
(the right first)
- 18 -