ANDELI TIG Series Instruction Manual page 17

workpiece；
protected code：
8
Display OC, indicating welding machine overheat or overcurrent protection；
Overheat protection is that the internal temperature of the machine is overheated, and the
machine can be restored to normal after cooling without load；
Overcurrent protection is unrecoverable when the machine is turned on without load, and
there may be original damage inside the machine. This situation needs to be carefully
handled and confirmed before starting the machine；If it is a misjudgment, just restart the
machine。
Function selector：
1
Function selector：switch Clean、TIG、Cold；
Function selector:
2
Function selector：switch current、gas delay、cold welding time、long press to save；
Parameter adjustment knob：
3
Adjust the value of each parameter, keep long press can adjust roughly；
Digital tube：
4
Display the values of each parameter；
(Figure 6) TIG-250GLC Panel
(The left first)
(The right first)
- 16 -