Table of Contents
Advertisement
SATA Mode Selection
The optional settings are: [IDE]; [AHCI].
IDE Legacy / Native Mode Selection
The optional settings are: [Native]; [Legacy].
For SATA device support Legacy OS (Like Dos), Please select Legacy for
compatible.
► PCH-FW Configuration
Press [Enter] to see ME information and make settings for Firmware Update
Configuration.
► Firmware Update Configuration
Press [Enter] to make settings for ME FW Image RE-Flash.
ME FW Image RE-Flash
Use this item to enable or disable ME FW Image Re-Flash function.
► USB Configuration
Press [Enter] to make settings for the following sub-items:
Legacy USB Support
The optional settings are: [Enabled]; [Disabled]; [Auto].
[Enabled]: To enable legacy USB support.
[Auto]: To disable legacy support if no USB devices are connected.
[Disabled]: to keep USB devices available only for EFI specification,
EHCI Hand-off
The optional settings are: [Disabled]; [Enabled].
USB hardware delay and time-out:
USB Transfer time-out
Use this item to set the time-out value for control, bulk, and interrupt transfers.
Device reset time-out
Use this item to set USB mass storage device start unit command time-out.
Mass Storage Devices:
The name of current generic flash disk will show when connected.
The optional settings are: [Auto]; [Floppy]; [Forced HDD]; [Hard Disk]; [CD-ROM].
► Super I/O Configuration
Press [Enter] to make settings for the following sub-items:
24
Advertisement
Table of Contents
