Table of Contents
Advertisement
228
IN CASE OF EMERGENCY
P
F
J
REPARATIONS
OR
ACKING
1. Park the vehicle on a firm level surface as far
from the edge of the roadway as possible.
Avoid icy or slippery areas.
WARNING!
Do not attempt to change a tire on the side of
the vehicle close to moving traffic. Pull far
enough off the road to avoid being hit when
operating the jack or changing the wheel.
2. Turn on the Hazard Warning Flashers.
3. Apply the parking brake.
4. Place the gear selector into PARK (P)
(automatic transmission) or REVERSE (manual
transmission).
5. Turn the ignition OFF.
6. Block both the front and rear of the wheel
diagonally opposite of the jacking position. For
example, if changing the driver's front tire,
chock the passenger's rear wheel.
Wheel Blocked
NOTE:
Passengers should not remain in the vehicle when
the vehicle is being lifted or raised.
J
L
/S
T
ACK
OCATION
PARE
IRE
The jack, tools, wheel chocks and spare tire
Ú page 290 are stowed under the load floor
behind the rear seat.
1. Open the liftgate.
2. Lift the load floor handle, then lift access cover
to locate jack and tools.
3. Remove the hook from the stowed position on
the back side of the load floor and place the
hook over the top body flange and weather
seal. This will hold the load floor up while
S
TOWAGE
obtaining the jack and spare tire.
4. Remove the fastener securing the jack and
spare tire.
Removing Jack And Spare Tire Fastener
Load Floor Handle
Advertisement
Table of Contents
