Fuses - Jeep 2022 CHEROKEE Owner's Manual

F
USES
General Information
WARNING!
When replacing a blown fuse, always use an

appropriate replacement fuse with the same
amp rating as the original fuse. Never replace
a fuse with another fuse of higher amp rating.
The use of a fuse with a rating other than indi-
cated may result in a dangerous electrical
system overload. If a properly rated fuse
continues to blow, it indicates a problem in the
circuit that must be corrected. Never replace a
blown fuse with metal wires or any other mate-
rial. Do not place a fuse inside a circuit
breaker cavity or vice versa. Failure to use
proper fuses may result in serious personal
injury, fire and/or property damage.
Before replacing a fuse, make sure that the

ignition is off and that all the other services
are switched off and/or disengaged.
If the replaced fuse blows again, contact an

authorized dealer.
If a general protection fuse for safety systems

(air bag system, braking system), power unit
systems (engine system, transmission
system) or steering system blows, contact an
authorized dealer.
CAUTION!
If it is necessary to wash the engine
compartment, take care not to directly hit the
fuse box, and the windshield wiper motors with
water.
The fuses protect electrical systems against
excessive current.
When a device does not work, you must check the
fuse element inside the blade fuse for a break/
melt.
Also, please be aware that when using power
outlets for extended periods of time with the
engine off may result in vehicle battery discharge.
Blade Fuses
SERVICING AND MAINTENANCE
1 — Fuse Element
2 — Blade Fuse With A Good/Functional Fuse
Element
3 — Blade Fuse With A Bad / Not Functional Fuse
Element (Blown Fuse)
Underhood Fuses
The Power Distribution Center is located in the
engine compartment near the battery. This center
contains cartridge fuses, mini-fuses and relays. A
label that identifies each component is printed on
the inside of the cover.
CAUTION!
When installing the power distribution center
cover, it is important to ensure the cover is
properly positioned and fully latched. Failure to
do so may allow water to get into the power
distribution center and possibly result in an
electrical system failure.
269
8