Table of Contents
Advertisement
16
GETTING TO KNOW YOUR VEHICLE
1. Remove the emergency key by sliding the
mechanical latch on the back of the key fob
sideways with your thumb and then pulling
the key out with your other hand.
Emergency Key Removal
Emergency Key Removal
2. Separating key fob halves requires screw
removal (if equipped), and gently prying the
two halves of the key fob apart. Make sure not
to damage the seal during removal.
3. Remove the battery by turning the back cover
over (battery facing downward) and tapping it
lightly on a solid surface such as a table or
similar, then replace the battery. When
replacing the battery, match the (+) sign on the
battery to the (+) sign on the inside of the
battery clip, located on the back cover. Avoid
touching the new battery with your fingers.
Skin oils may cause battery deterioration. If
you touch a battery, clean it with rubbing
alcohol.
4. To assemble the key fob case, snap the two
halves together, reposition and secure the
screw.
WARNING!
The integrated key fob contains a coin cell
battery. Do not ingest the battery; there is a
chemical burn hazard. If the coin cell battery is
swallowed, it can cause severe internal burns
in just two hours and can lead to death.
If you think a battery may have been swal-
lowed or placed inside any part of the body,
seek immediate medical attention.
Keep new and used batteries away from chil-
dren. If the battery compartment does not
close securely, stop using the product and
keep it away from children.
Programming And Requesting Additional
Key Fobs
Programming the key fob may be performed by an
authorized dealer.
NOTE:
Once a key fob is programmed to a vehicle, it
cannot be repurposed and reprogrammed to
another vehicle.
Only key fobs that are programmed to the
vehicle electronics can be used to start and
operate the vehicle. Once a key fob is
programmed to a vehicle, it cannot be
programmed to any other vehicle.
Always remove the key fobs from the vehicle
and lock all doors when leaving the vehicle
unattended.
For vehicles equipped with Keyless
Enter 'n Go™ Ignition, always remember to
place the ignition in the OFF position.
(Continued)
WARNING!
WARNING!
Advertisement
Table of Contents
