LinMot B1100-PP Installation Manual page 11

LinMot Installation Guide
Motor wiring for Phase Currents below 2A RMS and 4A peak
Important:
Motor phases may only be connected to X3 if RMS current is below 2A and peak current is below
4A!
7.4 X5
X5 COM / Config
1 RS485_Tx+ Y
2 RS232_Tx
3 RS232_Rx
4 RS485_Rx+ A
5 GND
6 RS485_Rx-
7 RS485_Tx-
8 CAN_L
9 CAN_H
case Shield
DSUB-9 (m) RS232: Configuration on all controllers: use 1:1 connection cable to PC with only pins 2,3 and 5
connected. Use LinMot RS configuration cable (Art.-No. 0150-3307). Cable length < 30m.
®
NTI AG / LinMot
B
Z
www.LinMot.com Page 11/19