Under-Desk Mounting - Extron electronics DVI DA2 User Manual

Installation and Operation, cont'd
4.

Under-desk mounting

The DVI DA2 and DVI DA4 can be mounted under furniture
using the optional Extron MBU 125 under-desk mounting kit
(part # 70-077-01).
Under furniture mounting
To mount the unit under a desk or table:
1.
2.
3.
4.
5.
6.
7.
DVI DA2 and DVI DA4 • Installation and Operation
2-4
Attach the shelf to the rack with the four provided
10-32 x 3.4" screws.
If necessary, remove rubber feet from the bottom of the
unit.
Secure the under-desk mounting brackets to the unit with
the four provided 4-40 x 3/16" screws.
Hold the unit, with the mounting brackets attached, under
the furniture where it will be secured. Mark the position of
the holes on the underside of the furniture.
In the marked positions, drill four pilot holes 3/32" (2 mm)
in diameter and 1/4" (6 mm) deep.
Insert the four provided wood screws into the pilot holes
and tighten until approximately 1/4" (6 mm) of the screw
head is protruding.
Guide the holes of the mounting brackets over the
protruding screw head and slide the unit forward or
backward to seat it firmly under the furniture.
Tighten all four wood screws to secure the unit in place.