PREVOST H3-41 Manual page 57

or a 24-hour format (00:00:00 to 23:59:59). The
choice is made in the Set-Up Menu.
To display the clock:
• Use the MODE button to select the Multi-
Function Mode;
• Use the UP/DOWN arrow buttons to
display the time.
To change the time display:
• When the clock time is displayed, press the
SET button to select the hours digits. The
hours digits will flash when selected. Use the
UP/DOWN arrow buttons to select the
desired hour;
• Press SET a second time to select the
minutes digits. The minutes will flash when
selected. Use the UP/DOWN arrow buttons
to set the desired minute;
• To accept the displayed time and exit the
time set function, press SET a third time.
Note :
The seconds digits cannot be selected.
Alarm Clock Display
The alarm clock function permits the sounding of
a reminder tone at any desired time.
To display the alarm clock:
• Use the MODE button to select the Multi-
Function mode;
• Use the UP/DOWN arrow buttons to
display ALARM.
To change the alarm time:
• When the alarm time is displayed, press
the SET button to select the hours digits.
The hours digits will flash when selected.
Use the UP/DOWN arrow buttons to select
the desired hour;
• Press SET a second time to select the
minutes digits. The minutes will flash when
selected. Use the UP/DOWN arrow buttons
to set the desired minute;
• To accept the displayed time and exit the
alarm time function, press SET a third time.
Note :
The seconds digits cannot be selected.
To enable the reminder tone:
• Set the alarm time, or
• Press and hold the MODE button. The next
mode display will appear once the reminder
tone is enabled. The clock display with a bell
will appear on screen.
To disable the reminder tone:
• When the bell symbol is displayed, press and
hold the MODE button until the next mode
display appears. The clock display will
appear without the bell symbol.
To silence the reminder:
• Press any of the four buttons while the
reminder is sounding.
Trip Odometer Display
Two independent trip odometers are available
(Trip Odometer 1 and Trip Odometer 2). Each
one displays the distance traveled since it was
last reset.
To display a trip odometer:
• Use the MODE button to select the Multi-
Function Mode;
• Use the UP/DOWN buttons to display either
TRIP ODOMETER 1 or TRIP ODOMETER 2.
To reset a trip odometer:
• Display the trip odometer to reset (1 or 2);
• Press and hold the set button for 1 second.
Hourmeter Display
The hourmeter display accumulates and
displays the total time the engine has run. This
display is not resettable by the driver. To display
the hourmeter:
• Use the MODE button to select the Multi-
Function mode;
• Use the UP/DOWN buttons to display the
hourmeter.
Diagnostics Mode
The diagnostics mode provides two functions:
• Cluster self test mode - Contains several
tests to check the instrument cluster.
• Diagnostics messages - Reports the status
of various vehicle sub-systems.
Cluster Self Test Mode
As an aid in troubleshooting the instrument
cluster, the following tests are provided:
4-7
OTHER FEATURES