COACH INTERIOR
Warning :
To prevent fire, never put paper or
plastic wrappers in the ashtray. Empty ashtray
often.
Cigarette Lighter
The cigarette lighter is located below the ashtray.
Push lighter in to activate. When ready to use, it
will spring out automatically. Replace lighter in
non-activated position.
socket can be used to power 12 volt appliances
(e.g., flashlight, vacuum cleaner). The maximum
power consumption for appliances plugged in this
socket is 130 watts. Make sure the appliances
are equipped with suitable plugs that will not
damage the socket.
Note :
The cigarette lighter can be used after the
ignition key has been removed.
Adjustable HVAC Registers
The HVAC system has adjustable registers to
control air flow.
They are located on the
dashboard, refer to "Controls & Instruments"
chapter (page 3-19). The direction and volume of
air flow are adjustable.
Driver's Power Window
The driver's area is equipped with a power
window. The power window is controlled by using
the rocker switch located on the L.H. side control
panel. Refer to "Controls & Instruments" chapter
(page 3-4).
Sun Shades (Blinds)
Raising and lowering of the front blinds is
controlled by two 3-position rocker switches
located on the dashboard. Refer to "Controls &
Instruments" chapter (page 3-9).
The driver is protected from side glare by a
spring-release type blind on the left window.
The optional Plexiglas partition, located behind
the
driver, may also be equipped with the same blind.
Pull down and release the blind in the desired
position.
To raise the blind, depress the
unlocking lever.
The cigarette lighter
2-2
DRIVER'S LEFT WINDOW BLIND
Inside Mirrors
Two mirrors are located in the driver's area. The
left overhead mirror provides visibility in the
critical area on the R.H. side of the coach. Adjust
the left overhead mirror to see through the front
passenger windows. The central mirror allows
the driver to see passengers in the aisle.
Safety Belt
The driver's seat and the optional tour guide seat
are equipped with retractable safety belts.
fasten safety belt, pull latch plate slowly and insert
into the buckle until it locks (clicks). The inertia
reel is self-adjusting. Manual adjustment is not
required.
FASTENING SAFETY BELT
OEH3B214
To
OEH3B222