PREVOST H3-41 Manual page 12

COACH EXTERIOR
prevent continuous operation of the heating
elements.
Caution :
Do not attach stick-on type convex
mirror accessories to the heated mirror glass.
This could impede uniform heat distribution on the
mirror surface which could break the mirror.
Electrically Adjusted Mirror (Ramco
and Spartan)
Electrically-adjusted mirrors are adjusted by the
outside mirror controls located on the L.H. control
panel. Refer to "Controls & Instruments" chapter
(page 3-4).
Manual adjustment is also possible.
Manual Adjustment
Adjust the side-view mirrors until the side of the
coach is visible. Adjust the flat-type mirror until
the highway is in full view.
Manually Adjusted Mirror
(Spartan)
MIRRORS ADJUSTMENT SCREWS
Horizontal And Vertical Adjustment
Loosen the two Allen screws at the rear of the
mirror body. Adjust the mirror to the desired
angle, then tighten the screws.
Vertical Adjustment
Loosen the hexagonal head screw at the rear of
the mirror body. Adjust the mirror to the desired
angle, then tighten screw.
SPARTAN REAR-VIEW MIRRORS
Caution :
Tighten until snug.
Manually Adjusted Mirror
(Ramco)
FLAT
MIRROR
CONVEX
MIRROR
SETSCREWS
CENTERLINE
OF ARM
SCREW
MOUNTING
OEH3B120
BRACKET
RAMCO REAR-VIEW MIRRORS
Adjustment
Loosen the bolt on the bracket of the mirror body.
Adjust the mirror to the desired angle then tighten
bolt.
Head Mirror Adjustment
Loosen the fixing screws. Adjust the head of the
mirror then tighten fixing screws.
Caution :
Tighten until snug.
1-6
GASKET SUPPORT
SCREW
CABLE
ASSY
ARM
LOWER
COLLAR
Do not over tighten the screws.
MIRROR CONVEX
HEAD MIRROR
MIRROR
ARM
POSITION BALL CUP
HALVES SO THE JOINT
BETWEEN THEM LIES ON THE
CENTERLINE OF THE ARM.
MOUNTING
ENSURE THAT THE SETSCREWS
BOLT
ARE NOT ON THE JOINT BETWEEN
THE CUP HALVES.
Do not over tighten the screws.
BEARING
GASKET
&
RING
SCREW
SUPPORT
18202
BALL
STEM
BALL CUP
HALF
18201