Follett 7 Series Installation Manual page 17

LED Indicator Description
The LED Indicator is located behind the front panel.
Fig. 16
LED Name LED Color
Clean Green
— N/A
PM Red
Drip tray Red
Water leak Red
High amps Red
Service Red
Maintenance Yellow
Low water Yellow
Time delay Yellow
Sleep cycle Green
Making ice Green
Low bin Green
Power on Green
The dispenser is in Cleaning Mode. Dispenser is disabled to allow for cleaning of front panel.
Not used.
Six-month periodic maintenance required.
Drip tray full.
Internal leak in dispenser.
Auger gearmotor has exceeded 0.55A (0.33A for 230V). The HI amps and Time delay
LEDs will illuminate, the machine will shut down for one hour, the LEDs will turn off, and the
machine will resume normal operation.
8000 hour bushing check (call Follett technical service group at (877) 612-5086 or
+1 (610) 252-7301).
Enter Maintenance Mode by pressing and holding maintenance/clean switch for 5 seconds.
Unit will not make or dispense ice.
Insufficient water supply to machine or no low bin LED upon startup.
Ice production will not resume for at least 15 minutes after a full bin is achieved and a
minimum amount of dispense activity has elapsed.
After a full bin and 10 minutes of non-use, the unit goes into standby and will not produce ice
until either:
7 Series: 12 hours has elapsed, 15 Series: 4 hours has elapsed or ice has dispensed.
Gearmotor, compressor, and fan motor energized.
Bin switch closed calling for ice.
Power supplied to unit.
Description
Dispenser and Ice Machine - 115 V, 230 V, 220 V 17