Follett 7 Series Installation Manual page 16

11. Pour SafeCLEAN Plus solution into bin lid access spout until solution reaches and remains level at the
spout neck. (Because the cleaning solution reaches the internal components via overflow into the ice
transport tube, it is necessary to add cleaning solution until it remains level at the spout neck.)
12. Allow the SafeCLEAN Plus solution to remain in unit for 15 minutes.
13. While machine is cleaning, remove top and right side panel to access and clean air-cooled condenser.
14. Submerge ice dispense chute in the remainder of SafeCLEAN Plus solution for 2 minutes. Rinse with
clean, potable water.
15. Drain system by lowering drain tube into bucket.
16. Secure drain tube into holder.
17. Fill and drain twice with potable water. Secure drain tube.
18. Place a bucket under the dispense chute and remove cap. Note: Some SafeCLEAN Plus solution will
remain and drain out when cap is removed. Reposition cap on bin lid spout.
19. Reinstall front panel, ice dispense chute, and drip tray.
20. Press and hold maintenance/clean switch to exit Maintenance Mode.
User Interface and Exterior Cabinet
1. Press and release maintenance/clean switch so that only "ICE" displays in the user interface to enter
Cleaning Mode (and disable dispensing).
2. Plastic parts, including the user interface, can be cleaned with a non-abrasive glass cleaner. Clean
stainless steel panels with stainless steel cleaner.
3. Press and release maintenance/clean switch to put unit back into service.
16
Dispenser and Ice Machine - 115 V, 230 V, 220 V