Follett 7 Series Installation Manual page 10

Freestanding Installation
1. A clearance of at least 3" (7.6 cm) is required behind and on each
side of the dispenser for electrical connection and ventilation
(Fig. 4).
2. Rough-in the electrical service and water line.
§ Electrical: 115 V, single phase, 15A receptacle required. The dispenser
has an integral 8 ft (2.4 m) cord and plug.
§ Water: supply line (with shut-off valve) connects to the dispenser's
1/4" MPT inlet or John Guest push-in fitting.
3. If installing optional 6" Leg Accessory (item# 00956318), tilt or lay
base stand on side and screw each leg into stand (Fig. 8).
4. Remove four plastic, thread-protecting plugs from bottom of
dispenser.
5. Attach dispenser to base stand with supplied hardware (Fig. 5).
NOTICE!
If installing optional Drip Tray Drain Kit, refer to instructions
included with the Drip Tray Drain Kit.
10
Dispenser and Ice Machine - 115 V, 230 V, 220 V
Fig. 3
freestanding models
minimum 3" (7.6 cm)
clearance required
Fig. 4
Fig. 5
X4