Operating Conditions; Storage And Transport Conditions; The Volcano Medic 2 Hot Air Generator; Unpacking - Vapormed Volcano MEDIC 2 Instructions For Use Manual

4 . I M P O R TA N T R E M A R K S

4.1. Operating Conditions

Ambient conditions in which the speci-
fied aerosol characteristics are guar-
anteed:
+40°C
+104°F
+10°C
+50°F
Ambient temperature:
+10°C to +40°C (+50°F to +104°F)
30% - 80%
Relative humidity of ambient air:
30% to 80%
700hPa - 1060hPa
Atmospheric pressure:
700 hPa to 1060 hPa
The device features interference sup-
pression acc. to EN 60601-1-2 (see
Chapter 10. "Hot Air Generator", page
57).
Radiofrequency emitting equipment
(e.g. mobile phones) should not be
used in the immediate vicinity of the
device. In case of doubt, contact quali-
fied personnel.
4.2. Storage and Transport
Conditions
+60°C
+140°F
-20°C
-4°F
Ambient temperature:
-20°C to +60°C (-4°F to +140°F)
20% - 80%
Relative humidity:
20% to 80%
700hPa - 1060hPa
Atmospheric pressure:
700 hPa to 1060 hPa
Do not store or transport any parts of
the VOLCANO MEDIC 2 Vaporization
System in direct sunlight, wet rooms
(e.g. bathroom) or near damp objects.
Extreme fluctuations in ambient tem-
perature can lead to condensation and
damage the device's function.
22
5 . T H E VOLCA NO M E DIC 2 H O T A I R G E N E R AT O R

5.1. Unpacking

Take out the accessories and the Hot
Air Generator from the box. Immedi-
ately after unpacking, check whether
the Hot Air Generator, the accessories,
the Power Cord and the plug are all
included in the delivery and work prop-
erly. If you notice any defects, inform
the seller or the delivery agent imme-
diately.
The packing material (plastic
bags, polystyrene parts, box-
es etc.) must be kept out of
the reach of children as it is a potential
source of danger.
Please dispose of the packing mate-
rial in a proper and environmentally
friendly manner.
We recommend keeping the original
packaging in case it is required later
(transport, Service Center, etc.).

5.2. Installation

Before installing the Hot Air Generator
make sure that the information given
on the type label on the bottom side
of the device corresponds to the local
mains supply data.
All parts of the electrical system must
comply with currently applicable offi-
cial regulations.
Put the Hot Air Generator on a flat and
stable surface.
Take care that the Power Cord cannot
be damaged through kinking, crush-
ing or pulling.
Improper installation
lead to personal injury or ma-
terial damages, for which the
manufacturer cannot be held
responsible.

5.3. Operation

The Hot Air Generator was
developed for vaporizing the
cannabinoids listed in the in-
structions. Any other use is inappropri-
ate and potentially dangerous.
For use and maintenance, the user
must always follow the instructions
given in the Instructions for Use.
If you have any concerns, or if there are
any problems, immediately switch off
the Hot Air Generator and disconnect
the power plug from the socket. Do not
try to remedy the defect yourself. Con-
tact our Service Center directly.
Allow the device to cool down before it
is packed away.
23
may