Disassembly Of The Filling Chamber; Drying; Assembly Of The Filling Chamber Cap; Assembly Of The Filling Chamber - Vapormed Volcano MEDIC 2 Instructions For Use Manual

9. H Y G I E N E
9.4.3. Disassembly of the Filling
Chamber
Use Screen, or Drip Pad where applica-
ble, to push the Filling Chamber Cylin-
der upwards out of the Filling Chamber
Housing.
Push the Filling Chamber Cylinder out of the
Filling Chamber Housing
Push the lower Screen upwards out of
the Filling Chamber Housing.
Push the lower Screen out
Lower Screen
Filling Chamber
Chamber

9.4.4. Drying

All component parts of the Filling
Chamber must be completely dry be-
fore reassembly.
Put all component parts of the Filling
Chamber on a clean, dry, and absor-
bent pad and allow them to dry thor-
oughly. A hair dryer may be used for
faster drying. Do not dry in wet rooms
(e.g. not in the bathroom).
54
9.4.5. Assembly of the Filling
Chamber Cap
Assemble the components in the re-
verse order:
Cylinder
Slide the cap cylinder into the cap
housing until it clicks, then pull the cap
Filling
ring from above over the cap cylinder
Housing
to the cap housing.
When using hemp flowers, push the
upper Screen from below into the cap
cylinder until it clicks into the desig-
nated notch.
When using dronabinol solution, the
two Screens are not needed. Only the
Drip Pad is inserted instead of the
lower Screen.
9. H Y G I E N E
The upper Screen has to be
placed carefully into the in-
tended notch.
vance may result in plant particles in
the Valve Balloon that might be inhaled
subsequently.
9.4.6. Assembly of the Filling
Chamber
Push the Filling Chamber Cylinder
from above into the Filling Chamber
Housing and allow it to lock in place.
Insert the Screen or the Drip Pad into
the Filling Chamber from above. Screw
the Filling Chamber Cap onto the Fill-
ing Chamber in a clockwise direction.
Cap Ring
Cap Housing
Touch Guard
Cap Cylinder
Upper Screen
55
Non-obser-