Operating Conditions; Storage And Transport Conditions; The Volcano Medic Hot Air Generator; Unpacking - Vapormed VOLCANO MEDIC Instructions For Use Manual

4. IMPORTANT REMARKS

4.1. Operating Conditions

Ambient conditions in which the
specified aerosol characteristics are
guaranteed:
+40°C
+10°C
Ambient temperature:
+10°C to +40°C (+50°F to +104°F)
30% - 80%
Relative humidity of ambient air:
30% to 80%
Atmospheric pressure:
700 hPa to 1060 hPa
The device features interference sup-
pression acc. to EN 60601-1-2 (see
Chapter 10. "Hot Air Generator", page
45).
Radiofrequency emitting equipment
(e.g. mobile phones) should not be
used in the immediate vicinity of the
device. In case of doubt, contact qual-
ified personnel.
4.2. Storage and Transport
Conditions
+60°C
-20°C
Ambient temperature:
-20°C to +60°C (-4°F to +140°F)
20% - 80%
Relative humidity:
20% to 80%
Atmospheric pressure:
700 hPa to 1060 hPa
Do not store or transport any parts of
the VOLCANO MEDIC Vaporization
System in direct sunlight, wet rooms
(e.g. bathroom) or near damp objects.
Extreme fluctuations in ambient tem-
perature can lead to condensation
and damage the device's function.
16
5. THE VOLCANO MED IC HOT AIR GENER ATOR

5.1. Unpacking

The box contains all components as
well as the Instructions for Use. Keep
the Instructions for Use for future ref-
erence.
Take out the accessories and the Hot
Air Generator from the box. Immedi-
ately after unpacking, check whether
the Hot Air Generator, the accesso-
ries, the power cord and the plug are
all included in the delivery and work
properly. If you notice any defects,
inform the seller or the delivery agent
immediately.
The packing material (plastic
bags, styrofoam material,
boxes etc.) must be kept out
of the reach of children as it is a poten-
tial source of danger.
Please dispose of the packing mate-
rial in a proper and environmentally
friendly manner.
We recommend keeping the original
packaging in case it is required later
(transport, Service Center, etc.).

5.2. Installation

Before installing the Hot Air Gen-
erator make sure that the information
given on the type label on the bottom
side of the device corresponds to the
local mains supply data.
All parts of the electrical system must
comply with currently applicable offi-
cial regulations.
Put the Hot Air Generator on a flat and
stable surface.
Take care that the power cord cannot
be damaged through kinking, crush-
ing or pulling.
Improper installation
lead to personal injury or ma-
terial damages, for which the
manufacturer cannot be held respon-
sible.

5.3. Operation

The Hot Air Generator was
developed for vaporizing the
cannabinoids listed in the in-
structions. Any other use is inappro-
priate and potentially dangerous.
For use and maintenance, the user
must always follow the instructions
given in the Instructions for Use.
If you have any concerns, or if there
are any problems, immediately switch
off the Hot Air Generator and discon-
nect the power plug from the socket.
Do not try to remedy the defect your-
self. Contact our Service Center di-
rectly.
Allow the device to cool down before it
is packed away.
17
may