Table of Contents
Advertisement
10. H O T A I R G E N E R AT O R
10.8. Information on Electromagnetic Compatibility
10.8.1. Essential Performance
There are no essential perfomance characteristics according to the risk assessment.
10.8.2. Electromagnetic Environment
The device is intented for use in the electromagnetic environment specified below.
The customer or the user of the device should assure that it is used in such environ-
ment.
Emission test
Emissions test
Compliance
Group 1
RF emissions
CISPR 11
Class B
Harmonic emissions
Class A
IEC 61000-3-2
Voltage fluctuations/
Passed
flicker emissions
IEC 61000-3-3
Electromagnetic environment - Guidance
The VOLCANO MEDIC 2 Vaporization
System uses RF energy only for its internal
function. Therefore, its RF-emission is very
low and are not likely to cause any
interference in nearby electronic
equipment.
The VOLCANO MEDIC 2 Vaporization
System is suitable for use in all establish-
ments, including domestic establishments
and those directly connected to the public
low-voltage power supply network that
supplies buildings used for domestic
purposes.
62
10. H O T A I R G E N E R AT O R
Immunity Test
Immunity test
IEC 60601
test level
Contact ±8 kV
Electrostatic
discharge (ESD)
IEC 61000-4-2
Air ±15 kV
Electrical fast
5/50 ns,
transient/burst
100 kHz, ±2 kV
IEC 61000-4-4
Compliance
Electromagnetic
level
environment – Guidance
Contact ±8 kV
Floors should be wood,
concrete or ceramic tile.
Air ±15 kV
If floors are covered with
synthetic material, the
relative humidity should
be at least 30 %.
5/50 ns,
Mains power quality
100 kHz, ±2 kV
should be similar to
that of a typical residen-
tial, commercial or
hospital environment. If
the user requires
continuous function, it is
recommended that the
VOLCANO MEDIC 2
Vaporization System is
operated from an
uninterruptible power
supply or battery.
63
Advertisement
Table of Contents
