Application - Vapormed Volcano MEDIC 2 Instructions For Use Manual

7. T H E U S E O F H E M P F L O W E R S

7.3.1. Application

Press the touch button labeled 'HEAT'
to switch on the heater. Before putting
the Valve Balloon on the Filling Cham-
ber, stretch it tight so that the Valve
Balloon is placed vertically on the Hot
Air Generator when it is filled. When
the actual temperature is equal to the
set temperature put the Filling Cham-
ber with Cap on the Hot Air Generator
and rotate clockwise as far as possi-
ble. Put the Valve Balloon on the Filling
Chamber and allow it to lock in place.
This will open the Valve.
Press the touch button labeled 'AIR'.
The Valve Balloon will now fill with the
cannabis aerosol.
Stretch Valve
Balloon tight
When the Valve Balloon is filled, switch
off the pump by tapping the touch
button labeld 'AIR' again - and remove
the Balloon together with the Filling
Chamber.
To do this, grasp the Filling Chamber
Cap by the rotating knobs and un-
screw counterclockwise.
40
7. T H E U S E O F H E M P F L O W E R S
Remove Valve Balloon with Filling Chamber
Caution! Hot surface!
Do not touch any compo-
nents of the Filling Chamber
(except at the textured grip)
until it has cooled down after
the Valve Balloon has been filled.
Separate the Valve Balloon from the
Filling Chamber. The Valve closes au-
tomatically after separation and the
aerosol in the Valve Balloon cannot
escape.
Separate Valve Balloon from Filling Chamber
Do not leave the Filling Cham-
ber on the hot air outlet of the
VOLCANO MEDIC 2 when the heat is
switched on – except for filling the
Valve Balloon.
Caution! Hot surface!
41