Table of Contents
Advertisement
Defining CEC
VP-427X1
can be configured to automatically send CEC on/off commands to the connected
display (default) or to pass CEC commands from the connected source to the connected
display.
To set the CEC (Consumer Electronic Control) functionality:
1. On the front panel press MENU. The menu appears.
2. Click Advanced and select Output CEC Bypass.
3. Select:
▪
Off – Automatically send CEC commands to shut down the output display after a
timeout period when no input signal is found and to power up the display when the
input returns.
▪
On – Pass CEC commands from the source to the display.
CEC functionality is defined.
Configuring TOGGLE Pin Behavior
VP-427X1
enables defining the function of the REMOTE pin
To configure the TOGGLE pin (see
1. On the front panel press MENU. The menu appears.
2. Click Advanced and select Toggle Pin.
3. Select the TOGGLE pin configuration:
▪
Edge = (toggle on/off).
▪
Input Select.
▪
GND=Off / Hi=On
▪
GND=On / Hi=Off
▪
Hi=Off
Defining HDBT Range
VP-427X1
enables defining the HDBT port range.
To define HDBT extra range:
1. On the front panel press MENU. The menu appears.
2. Click Advanced and select HDBT Extra Range.
3. Select:
Off – 1080p signal extends to 130m.
▪
▪
On – extra range, 1080p signal extends to 180m.
HDBT range is defined.
VP-427X1 – Operating and Controlling VP-427X1
Connecting the Remote Control Switches
Kramer Electronics Ltd.
13
on the rear panel.
on page 9):
17
Advertisement
Table of Contents
