ITT PumpSmart PS220 Configuration And Operation Manual page 110

PS220 Configuration & Operation Guide
8.3 Relay Configuration Wizard
The PumpSmart PS220 has 3 Form C "Dry Contact" relays on board as standard. They are fully configurable for different
pumping system and electrical system operating conditions, to include warnings, and for fault conditions. Relays will
revert to their original states once any warnings, faults, or the operating conditions that triggered them are reset or
cleared. Each can be forced on, off, and inverted. By default, Relay 1 is configured for Ready, Relay 2 is configured for
Running, and Relay 3 is configured for Fault. Additional relays can be added with the use of optional plug-in extension
modules available from ITT.
Note:
To access this Wizard from the Home Screen, follow the path: Menu>PS220 Configuration>I/O Configuration>No> (OR
Yes, if you are configuring the FIO-11optional Extension Module for the first time)>Relays >Select
The steps that you will perform:
1. Configure the Assignment for the Relay by Number.
2. Exit the Wizard
The Screen Shots that follow will show you step by step as you progress, from start to finish as you progress, how to con-
figure this functionality.
2. Exit Wizard
1. "Next" to end.
NOTE:
For "Other" contact your ITT Monitoring & Control Application Engineer or Commissioning Engineer.
109 PS220
1. "ARROW UP/DOWN" to change
2. "SAVE" to continue
3. Repeat steps 1-2 for additional relays
that need configuration.