Using The Remote Controls - Dish Network 118523 User Manual

Chapter 3
Using the System
Tip: Remote
Control 1 is used to
control TV1 menus
on the nearby TV.
Remote Control 2
is used to control
TV2 menus on the
remote TV(s).
Page 52
Switching Between Dual and Single Mode
Put the satellite receiver in
button. Keep the following items in mind when switching the satellite
Mode
receiver between
Dual and Single Mode
DUAL MODE front panel
Indications
indicator lights.
The RECORDING front
panel indicator lights to
Recording
show which TV is currently
recording.
Favorites Lists
both outputs (
Favorites
are available.
Lists
Locks
outputs (
Locks
available.

Using the Remote Controls

The following section describes how to use the remote controls with your
satellite receiver. The remote control must be in SAT mode for the buttons to
control the satellite receiver. You can also use the remote to control your VCR
and other devices. See Control Other Devices with the Remote on page 106.
SAT Mode Button
Press the SAT mode button to set the remote to SAT mode, to control the
receiver. The SAT mode button's back light turns ON briefly to show that the
remote is set to SAT mode.
Power Buttons
Press the blank POWER button to turn TV1 or TV2 (depending on which
remote is being used) ON or OFF. Press the TV POWER button to turn the TV
on or off.
: You must program the remote to control your TV for the TV POWER
Note
button to work as described. See page 106 for instructions.
or
Dual Single Mode
:
Dual Mode
set up for
and )
TV1 TV2
set up for both
and ) are
TV1 TV2
by pressing the front panel
Single Mode
SINGLE MODE front
panel indicator lights.
The TV1 RECORDING
front panel indicator lights
when you are recording
from one or both tuners.
set up for
Favorites Lists
only are available. The
TV1
lists for are not lost,
TV2
they are simply unavailable
in .
Single Mode
set up for only
Locks TV1
are available. The locks for
are not lost, they are
TV2
simply unavailable in
.
Single Mode