Setting Up Tv1 To Operate In Ir - Dish Network 118523 User Manual

Setting Up TV1 to Operate in IR

The following instructions describe how to set up TV1 to operate in IR only.
1. Perform the following with an existing remote control:
a. Open the
TV1 UHF Pro Setup
remote control.
b. Select
Disable
c. Select
System Info
2. Perform the following with an IR remote control, such as a Remote Control
5.0 (as shown on the back of the remote), that you intend to use to control
TV1:
a. Press the RECORD button. The
b. Make sure the
Remote Address
screen by pressing MENU-6-1-8 on the
from the
TV1 UHF Pro Setup
to open the
System Information
Done
screen shows that the
System Information
shows .
IR
Setting Up TV1 to Operate in IR
screen.
screen.
button should be highlighted.
Primary
Page 47