Dish Network 118523 User Manual page 45

Chapter 2
Receiver Description and Installation
Page 40
3. On Remote Control 1, press MENU-6-1-1 to display the
screen on the nearby TV.
4. Select
Check Switch
5. The receiver begins performing the
finished, the
Installation Summary
6. Make sure that the information on the
identifies your system correctly and shows all transponders for all satellites
in your system. Your screen may look different from the example above
depending on the dish antenna system you are using.
7. Select to go to the
OK
8. Select to exit the Point Dish menu. An
Cancel
asking the mounting and positioning of your dish is complete with a
indication in the
Locked
Yes.
9. After you select Yes, the receiver will begin taking a software upgrade. You
will see a Warning that
downloaded into your receiver
progress of this upgrade.
10. Once the software upgrade is complete, you will see a message that your
receiver's memory is being upgraded.
11. Do not disturb the receiver while the receiver's memory is being upgraded.
: If you are installing other DISH Pro or DISH Pro Plus receivers, be
Note
sure to run
Check Switch
necessary software upgrade.
12. When the memory upgrade is complete, you should be watching TV. Your
dish antenna installation is now complete.
. When an attention screen displays, select
Check Switch
screen displays.
Installation Summary
screen.
Point Dish/Signal
screen. If the answer is yes, select
Point Dish
Vital program information will now be
. You will also see a status bar showing the
on all of them, and allow them to take the
Point Dish/Signal
.
Retest
tests. When it is
screen
screen will open
Attention