Scan For Device Codes - Dish Network 118523 User Manual

Scan for Device Codes

If the code for your device is not listed in the tables starting on page 147, use
this procedure to scan the remote control's memory for the device code.
Instructions
1. Turn the device on.
2. Press and hold the mode
button until all the other mode
buttons light up, and then let
go of the button.
The mode button flashes.
3. For AUX mode only.
• Press 0 for a second TV.
• Press 1 for a second VCR
or DVD player.
Press 2 for a tuner or
•
amplifier.
4. For AUX mode only: Press
the STAR button.
5. Press the blank POWER
button.
6. Press the UP or DOWN
ARROW button repeatedly
until the device turns off.
7. Press the POUND (#) button.
Control Other Devices with the Remote Controls
Additional Information
Use the device's front panel buttons
or its remote control.
For example, hold the TV mode
button for a TV until all of the other
mode buttons light. When you let
go, the TV mode light will flash.
This step is for programming which
kind of device that should be
programmed in AUX mode. If
you're not programming in AUX
mode, skip to step 4.
This puts your remote in the scan
mode.
As you press the UP or DOWN
ARROW button, the remote is
trying each code in the memory to
see if it can turn off your device.
When the device turns off, you have
found a code that might work.
Note: The mode button for the
device will flash rapidly eight times
when you've scanned all the codes
for that device.
This stores the code you found.
Page 109