Dvr Buttons - Dish Network 118523 User Manual

3. If you see the
System Info
screen. You have recovered your satellite video.
4. If you do not see the
have recovered your satellite video.
: Press any remote control button other than the RECOVER button to
Note
end this procedure.
: If the RECOVER button is not programmed to a specific channel,
Note
the RECOVER button will first try to tune your TV to channel 3, then
channel 4, and then other video inputs with each press of the RECOVER
button. You may need to press the RECOVER button up to 30 times to
recover your satellite TV video. If the RECOVER button is programmed to
a specific channel (see page 25), the RECOVER button will tune the TV to
the specific channel (for example, channel 60).
Use these buttons to record or play back a DVR program. See Using the DVR
Features on page 85 for details.
PIP Button
Press the PIP button to open the
press this button again. Press the button a third time to close the
This button is active only in
Swap Button
Press the SWAP button to swap the video in the main display with the video in
the window. This button is active only in
PIP
Position Button
Press the POSITION button to move the
the TV screen. Each press of this button move the
active only in
Single Mode
screen, press the SELECT button to close the
screen, repeat steps 2 and 3 until you
System Info

DVR Buttons

window. To make the
PIP
.
Single Mode
Single Mode
window to different positions on
PIP
.
Using the Remote Controls
window larger,
PIP
window.
PIP
.
window. This button is
PIP
Page 57