Table of Contents
Advertisement
PC7501 User's Manual
5.2.3 LAN Interface
□
Was the PC7501 shut off and restarted after the IP address was set?
□
Is the interface selection switch on the rear panel of the emulator PC7501 set to "LAN"?
T
□
Is the 10BASE-T cable connected correctly to both the emulator PC7501 and the hub?
T
□
If the PC7501 and host machine are directly connected, are they connected by a 10BASE-T
cross cable?
□
If the PC7501 replies to the ping command in the DOS window, recheck the settings in the Init
dialog box of the emulator debugger M3T-PDxxF.
□
The interface setting of the emulator debugger M3T-PDxxF is specified by the Init dialog box.
Recheck the setting.
□
Is the emulator debugger M3T-PDxxF set for the LAN interface?
□
If the PC7501 and host machine are set to separate networks, execute the ping command for the
PC/EWS on the network to which the PC7501 is connected. If no reply is received, check the
network setting of the host machine.
□
If the PC7501 and host machine are set to separate networks, is a gateway set in the OS?
(192.168.1.254 in the figure below)
□
Does an IP address for a gateway registered with the PC7501 specify the gateway that the
PC7501 uses? (192.168.2.254 in the figure below)
+*
192.168.1.1
/50-/34-/-/
Network ID: 192.168.1.0
A?@B9= 876 /50-/34-/-.
Figure 5.1 Network configuration
R20UT0207EJ0500 Rev.5.00
Nov 01, 2010
3.2.1 Interface Selection Switch (P.22)
T
4.2.3 Connecting by LAN Interface (P.31)
T
Gateway
>9@;<:
192.168.1.254
/50-/34-/-021
192.168.2.254
/50-/34-0-021
Network ID: 192.168.2.0
A?@B9= 876 /50-/34-0-.
192.168.2.1
/50-/34-0-/
5. Troubleshooting
Page 40 of 50
Advertisement
Table of Contents
