Connecting By Lan Interface - Renesas PC7501 User Manual

PC7501 User's Manual

4.2.3 Connecting by LAN Interface

To connect the emulator PC7501 by use of a LAN interface, you need to register some network information such as an
IP address, a subnet mask, a port number, etc. in the emulator PC7501 in addition to the ordinary setup information.
There are following two ways to setup and to register the network information.
• Using the emulator debugger M3T-PDxxF
• Using the utility SETIP.EXE
If you incorporate the host machine and the PC7501 in separate networks, read "Incorporating the emulator PC7501 in a
different network" (P.33) too.
(1) Using the emulator debugger M3T-PDxxF
This method can be executed with all the OS's on which the M3T-PDxxF runs.
First, use a USB or an LPT parallel interface other than LAN interface to start up the emulator PC7501 and register the
network information from the emulator debugger M3T-PDxxF. When the registration of the network information in the
emulator PC7501 is completed, you can connect the emulator debugger M3T-PDxxF to the emulator PC7501 by use of
the LAN interface.
The setup procedure is as follows.
Connect over a LPT parallel interface as explained in "4.2.1 Connecting by LPT Parallel Interface"
(P.27) or USB interface as explained in "4.2.2 Connecting by USB Interface" (P.29), according to the
equipment status of the host machine OS and communication interface.
If the environment allows you to use both USB and LPT parallel, it is recommended to select the LPT
parallel interface.
Register network information in the PC7501 as described in "Setting of the LAN Interface" of the
emulator debugger M3T-PDxxF user's manual (or Online Help).
Quit the emulator debugger M3T-PDxxF.
Turn power to the host machine, PC7501 and target system OFF.
Disconnect the LPT parallel or USB interface cable used earlier from the PC7501 and host machine.
Switch the interface selection switch on the rear panel to "LAN."
Connect a 10BASE-T cable to the LAN interface connector of the PC7501.
Turn ON the power to the host machine and then turn ON the power of the PC7501 and the target
system as simultaneously as possible.
Start up the emulator debugger M3T-PDxxF. (Select LAN on the MCU tab of the Init dialog box.)
R20UT0207EJ0500 Rev.5.00
Nov 01, 2010
4. Setup
Page 31 of 50