Specifications - Renesas PC7501 User Manual

PC7501 User's Manual

2.4 Specifications

Table 2.1 lists the specifications of the emulator PC7501.
Table 2.1 Specifications
Supported MCUs
Max. operating clock frequency
Emulation memory
Software break
Hardware break
Hardware break condition
Exception event detection
Real-time trace
Real-time RAM monitor
Execution time measurement
C0 coverage
External trigger input/event output External trigger input (MCU-dependent-voltage CMOS level x8) or event output
Host machine interface
Connection to the target system
AC supply voltage for emulator
unit
Power consumption
4
External dimensions *
P
P
Weight
Operating environmental
conditions
Storage environmental conditions - Temperature: -10° to 60°C
*1 Target-MCU-dependent. (For details, see an emulation probe user's manual.)
*2 Available memory and the required wait states depend on the target MCU. (For details, see an emulation probe user's
manual.)
*3 The number of user-settable hardware break points depends on the specifications of the emulator debugger
M3T-PDxxF.
*4 For details of the external dimensions, refer to "7.1 External Dimensions of the Emulator PC7501" (P.45).
R20UT0207EJ0500 Rev.5.00
Nov 01, 2010
M16C Family and R8C Family (32/16-bit or 16-bit)
1
66.7 MHz *
P
P
2
The default is 4 MB *
P
P
64 points
3
16 points *
P
P
(Execution address/Bus detection/Interrupt/External trigger signal)
- AND/OR/AND (same time)/State transition
- Pass count: 255 times
Access protect
- 256K cycles
- Trace data: Bus, external trigger, and time stamp
- Five trace modes: Break/Before/About/After/Full
- Can be recorded ON/OFF by events
- 4,096 bytes (256 bytes x 16 blocks)
- Data/Last access result
- Execution time between program start to stop.
- Maximum/minimum/average execution time and pass count of specified four
zones.
- Count clock: Equal to MCU Clock or 16 MHz
8,192 KB (256 KB x 32 blocks)
(break x1, event x7)
- LPT parallel (ECP, EPP, Byte/compatibility and Nibble/compatibility modes)
- USB (USB 1.1, full-speed)
- LAN (10BASE-T)
By way of an emulation probe (optional)
(For details, see emulation probe data sheets.)
Supplied from an included AC adapter (100 - 240 V, 50/60 Hz)
48 W maximum
Width: 433 mm, Depth: 140 mm, Height: 58 mm
740 g
- Temperature: 5° to 35°C
- Humidity: 20% to 80% (non-condensing)
- Dust and dirt: General office environment
- Humidity: 0% to 90% (non-condensing)
- Dust and dirt: General office environment
2. PC7501 System Configuration
Page 18 of 50